KIT-GASKET-CL 2655321 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-4077 Camshaft Bearing Tool 1
125-2739 (1) Bearing Pilot 1
125-2740 (1) Back Up Plate 1
125-2741 (1) Bearing Sleeve 1
B 8S-2241 Camshaft Bearing Tool Group 1
C 5P-5247 Hydraulic Puller 1
D 8H-0684 Ratchet Wrench 1
(1) Alternate Tooling for camshaft bearings with a large diameterStart By:
Remove camshafts.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01208871
Use the following steps to install Tooling (A).
Install the pilot group in camshaft bearing (1) (not shown).
Place the backup plate in position and ensure that camshaft bearing (1) (not shown) is between the two parts.
Install the bolt that holds Tooling (A) together.
Use the extensions to obtain the correct length for Tooling (A).
Install the puller plate on the bolt and the flywheel housing or the front housing.Note: Tooling (B) can be used to remove the camshaft bearings when the flywheel housing and the front housing have been removed.
Illustration 2 g01208875
Install Tooling (C) on Tooling (A). Pull camshaft bearing (1) from the cylinder block.Note: Tooling (D) can be used in place of Tooling (C), if necessary.Installation Procedure
Illustration 3 g00578338
Install camshaft bearing (1) on Tooling (A).Note: Tooling (B) can be used to install the camshaft bearings when the flywheel housing and the front housing have been removed.
Illustration 4 g02108639
Rear View
(X) Location of camshaft bearing joints
(Y) Location of oil holes
Position camshaft bearing (1) and Tooling (A) in the bore.Note: The camshaft bearing joint must be on the horizontal centerline of the bore. The upper oil hole must be 20 5 degrees above the horizontal centerline of the bore. The lower oil hole of the camshaft bearing must be 20 5 degrees below the horizontal centerline of the bore. The camshaft bearing joints must face the inside the cylinder block.
Illustration 5 g00578349
Install Tooling (C) on Tooling (A) and pull the camshaft bearing into the bore.Note: Tooling (D) can be used in place of Tooling (C).
After the camshaft bearing is installed, measure the bore. The bore must be 92.00 0.06 mm (3.620 0.002 inch).