KIT-SEAL 2764434 - Caterpillar

Illustration 1 g06329633
Typical example
Illustration 2 g06329638
Right side view
Typical example
Illustration 3 g06329641
Front view
Typical example
Table 1
Item Qty Part Specification Description
1 1 2W-1053 Plug Torque to 100 15 N m (74 11 lb ft).
2 2 7N-7697 Plunger The cooling jet sequence valves must start to open at a pressure difference of 130 30 kPa (19 4 psi).
The cooling jet sequence valves must be fully open at a pressure difference of 200 30 kPa (29 4 psi).
3 8 0S-1594 Bolt Use the following procedure to tighten the bolts of the clamp assembly:
1. Tighten the clamp assembly until the clamp assembly snug to tube.
2. Tighten the clamp assembly to the adapter.
3. Tighten the clamp assembly to the tube.
4 2 6B-9202 Spring Length under test force is 68.3 mm (2.69 inch).
Test force is 85 to 100 N (19.0 to 22.4 lb).
Free length after test is 112.7 mm (4.44 inch).
5 8 0S-1571 Bolt Use the following procedure to tighten the bolts of the clamp assembly:
1. Tighten the clamp assembly until the clamp assembly snug to tube.
2. Tighten the clamp assembly to the adapter.
3. Tighten the clamp assembly to the tube.
6 2 237-7623 O-Ring Seal Before assembly, lightly lubricate the bore with the fluid that is being sealed.
7 4 109-2332 O-Ring Seal Before assembly, lightly lubricate the bore with the fluid that is being sealed.
8 3 1P-1367 Plunger The plunger of the engine oil filter bypass valves must move freely in the bore.
During engine operation, the engine oil filter bypass valves must start to open at a pressure difference of 203 20 kPa (30 3 psi).
9 3 7G-6713 Spring Length under test force is 57.2 mm (2.25 inch).
Test force is 109.0 5.0 N (24.5 1.1 lb).
Approximate free length after test is 99.7 mm (3.93 inch).
10 1 2W-1969 Bypass Valve The oil cooler bypass valve must open with a pressure difference of 180 20 kPa (26 3 psi).
11 1 2W-1635 Spring Length under test force is 102.0 mm (4.02 inch).
Test force is 518 26 N (116 6 lb).
Free length after test is 143.4 mm (5.65 inch).