2839990 KIT-BRAKE LINING Caterpillar parts
814F, 814F II, 815B, 815F, 815F II, 816F, 816F II, 824G, 824G II, 824H, 824K, 825G, 825G II, 825H, 825K, 826G, 826G II, 826H, 826K, 966F II, 970F, 980G, 980G II, 980H, 980K, 980K HLG, R1700 II
Illustration 1 g00753251 Open the drain on the water separator bowl (3). Allow the water and fuel to drain into a suitable container. Support the water separator element and rotate the locking ring (1) counterclockwise. Remove the water separator. Remove the water separator bowl (2) from the bottom of the water separator element.Note: The water separator bowl is reusable. Do not discard the water separator bowl. Inspect the O-ring seal of the water separator bowl for damage. Replace the O-ring seal, if necessary. Lubricate the O-ring seal with clean diesel fuel or lubricate the O-ring seal with motor oil. Place the seal in the water separator bowl. Spin the water separator bowl onto the new element by hand until the water separator is snug. Do not use tools to tighten the water separator element to the bowl. Clean the filter mounting base. Install the new element. Rotate the locking ring clockwise in order to fasten the filter to the mounting base. Prime the fuel system in order to fill the fuel filter/water separator element with fuel. Refer to Operation and Maintenance Manual, "Fuel System Priming Pump - Operate". Close the engine access door.
