KIT-DT GASKET 2925516 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Generator - Dry
Generator Bearing - Lubricate
Generator Set Alignment - Check
Generator Winding - Test
Space Heater - Test
Stator Winding Temperature - Test
Throttle Control Valve - Check
Daily
Engine Oil Level - Check
Fumes Disposal Filter Differential Pressure - Check
Generator Load - Check
Every Week
Air Tank Moisture and Sediment - Drain
Automatic Start/Stop - Inspect
Battery Electrolyte Level - Check
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Fuel Filter Differential Pressure - Check
Generator Bearing Temperature - Test/Record
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Walk-Around Inspection
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Every 1000 Service Hours
Crankcase Pressure - Measure
Valve Stem Projection - Measure/Record
Every 1000 Service Hours or 6 Months
Engine Oil - Change
Engine Oil Filter - Change
Every 2000 Service Hours
Carburetor Air/Fuel Ratio - Check/Adjust
Compressor Bypass - Check
Generator - Inspect
Every Year
Aftercooler Condensation - Drain
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Crankcase Blowby - Test/Record
Crankshaft Vibration Damper - Inspect
Cylinder Pressure - Test/Record
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash and Bridge - Check
Gas Pressure Regulator Condensation - Drain
Generator Bearing - Lubricate
Generator Set Vibration - Test/Record
Generator Winding Insulation - Test
Hoses and Clamps - Inspect/Replace