KIT-MODULE-INLET 2949275 - Caterpillar

Removal Procedure
Start By:
Prepare the machine for disassembly. Refer to Disassembly and Assembly, "Preparation for Disassembly".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00632693
Disconnect hydraulic hose assemblies (1) and (3) from the pressure reducing valve.
Remove bolt (4). Separate the resolver from the pressure reducing valve.
Remove bolt (2). Remove the pressure reducing valve from the machine.Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 2 g00632693
Place the pressure reducing valve in position. Install bolt (2). Do not tighten bolt (2) at this time.
Connect the resolver to the pressure reducing valve. Install bolt (4). Tighten bolts (2) and (4) .
Connect hydraulic hose assemblies (1) and (3) .