KIT-SEAL 2976850 - Caterpillar

Table 1
Event Codes    
Code and Description    Conditions which Generate this Code    System Response    
99-15
Engine Oil Filter Differential Pressure : High - least severe (1)     The difference between the filtered oil pressure and the unfiltered oil pressure is greater than the trip point pressure.     The code is logged.
The ECM may derate the engine or shutdown the engine.    
99-0
Engine Oil Filter Differential Pressure : High - most severe (3)    
E073(1)
High Oil Filter Differential Pressure - lease severe     The difference between the filtered oil pressure and the unfiltered oil pressure is greater than the trip point pressure.     The code is logged.
The ECM may derate the engine or shutdown the engine.    
E073(2)
High Oil Filter Differential Pressure - moderate severity    
E073(3)
High Oil Filter Differential Pressure - most severe    Probable Causes
Oil filter
Oil pressure sensor circuit
Oil filter bypass valveRecommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in the order of the listed test steps.
Table 2
Troubleshooting Test Step    Value    Result    
1. Plugged oil filter or faulty oil filter
A. manually check the oil filter differential pressure. If the oil filter differential pressure is too high, change the oil filter elements.
   
Oil Filter
   
Result: After starting the engine, the event code is no longer active for the filter that was changed.
STOP
Result: After starting the engine, the event code remained active for the filters that were changed.
Proceed to the Test Step 2.
   
2. Oil pressure sensors and/or circuits
A. Do not start the engine. Use the Caterpillar Electronic Technician (ET) to compare the readings of the "Unfiltered Oil Pressure (abs)" and the "Engine Oil Pressure (abs)".
    Sensor circuit    
Result: Both sensors read atmospheric pressure while the engine is off.
Proceed to the Test Step 3.
Result: A sensor does not read atmospheric pressure while the engine is off.
Repair: Troubleshoot the sensor circuit. Refer to Troubleshooting, "Sensor Signal (Analog, Active) - Test".
Verify that the repair eliminated the problem.
   
3. Oil Filter Bypass Valve
An oil filter bypass valve that is stuck in the closed position can cause a high reading for differential pressure when the oil is cold.
An oil filter bypass valve that is stuck in the open position can cause a low reading for differential pressure when the oil is hot.
A. Determine if the valve is stuck.
   
Filter bypass valve
   
Result: The bypass valve is OK.
STOP
Result: The bypass valve is not OK.
Repair: Repair the valve or replace the valve.
Verify that the repair eliminated the problem.
   If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).