KIT-SPIDER & BEARING 3043265 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 284-5122 Stand 1
8S-7641 Tube 1
8S-7615 Pin 1
8S-8048 Saddle 1 Start By:
Remove Bucket.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g06111270
Position tooling (A) under loader frame as shown.
Illustration 2 g06111297
Disconnect hose assemblies (1).
Illustration 3 g06111311
Remove clamp (2) and tube assembly (3).
Illustration 4 g06111326
Attach a suitable lifting device to lift cylinder (5) as shown. The approximate weight of lift cylinder (5) is 250 kg (550 lb).
Remove pins (4) and (6). Remove lift cylinder (5).
Repeat Step 2 through Step 5 for opposite side.Install Procedure
Install Cylinder (5) in reverse order of removal.