KIT-GASKET-RS 3050791 - Caterpillar

Use this procedure if the diagnostic code in Table 1 is active.
Table 1
Codes That Relate to Configuration Parameters
J1939 Code CDL Code Code Description
(code descriptions may vary) Comments
630-2 268-2 Programmed Parameter Fault : Erratic, Intermittent, or Incorrect The engine Electronic Control Module (ECM) detects that one or more of the programmable parameters have not been programmed.
The ECM may use a default torque map or the ECM may limit the engine to low idle.
The code is active only.
Follow the troubleshooting procedure to identify the root cause of the problem. The electronic service tool can be used to view certain parameters that can affect the operation of the engine. The electronic service tool can also be used to change certain parameters. Some parameters cannot be changed and some applications do not allow any changes to the programmable monitoring system. The parameters are stored in the Electronic Control Module (ECM). Some of the parameters are protected from unauthorized changes by passwords. Parameters that can be changed have a tattletale number. The tattletale number shows if a parameter has been changed.The parameters are divided into two different types:Customer Specified Parameters - Customer passwords may be required to change the values of customer specified parameters.System Configuration Parameters - System configuration parameters affect the emissions of the engine or the power of the engine. Factory passwords may be required to change the values of system configuration parameters.
Illustration 1 g03747092
Typical configuration screen
Connect to the electronic service tool.
Select the Service tab.
Select the Configuration tab to view the configuration parameters.If the ECM is replaced, the appropriate parameters must be copied from the old ECM. Copy the parameters with the "Copy Configuration" feature of the electronic service tool. The "Copy Configuration" tab is below the "Configuration" tab. Alternatively, the settings can be recorded on paper and then programmed into the configuration screen for the new module.
Changing the parameters during engine operation can cause the engine to operate erratically and can cause engine damage.Only change the settings of the parameters when the engine is STOPPED.
Check Programmable Parameters 630-2 (268-2)
Illustration 2 g03747100
Typical active diagnostic codes screen
If a programmable parameter has not been programmed, the ECM will generate a 630-2 (268-2) diagnostic code. The programmable parameter that is not programmed will be listed under the code. Illustration 1 shows the parameters that are not programmed under the 630-2 (268-2) code. The unprogrammed parameters will be set to default. Certain aspects of the engines performance and engine monitoring may be affected.If "Injector Trim" is displayed below a 630-2 (268-2) diagnostic code on the electronic service tool, refer to Troubleshooting, "Injector Trim File - Install".