KIT-ENGINE GASKET 3052664 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Illustration 1 g00671513
Disconnect the fuel lines (1) from the fuel transfer pump (3). Cap all the male ends and plug all the female ends immediately after the lines are removed.
Remove two bolts (2). Remove fuel transfer pump (3) .
Illustration 2 g00556879
Typical example
Remove O-ring seal (4) from fuel transfer pump (2) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Note: Check the condition of the O-rings. If the O-rings are worn, use new parts for replacement.
Illustration 3 g00556879
Typical example
Install O-ring seal (4) on fuel transfer pump (2) .
Illustration 4 g00671513
Install fuel transfer pump (3) .
Install two bolts (2) .
Connect two fuel lines (1) to fuel transfer pump (3) .