KIT-SEAL 3093932 - Caterpillar

Personal injury or death could result when towing a disabled machine incorrectly.Block the machine to prevent movement before releasing the brakes. The machine can roll free if it is not blocked.
The machine is equipped with spring applied brakes. These brakes are also oil pressure released brakes. If the engine or the system for pressure oil is inoperable, the brakes are applied and the machine cannot be moved. The machine can be moved if the sun gear for the final drive is removed.Reference: Refer to Disassembly and Assembly Manual for the proper procedure to remove the sun gear.These towing instructions are for moving a disabled machine for a short distance at low speed. Move the machine at a speed of 2 km/h (1.2 mph) or less to a convenient location for repair. These instructions are only for emergencies. Always haul the machine if long distance moving is required.Shields must be provided on both machines. This shielding will protect the operator if either the tow line or the bar breaks.Before towing, make sure that the tow line or the bar is in good condition. Make sure that the tow line or the bar has enough strength for the towing procedure that is involved. The strength of the towing line or of the bar should be at least 150 percent of the gross weight of the towing machine. This condition is true for a disabled machine that is stuck in the mud and for towing on a grade.For towing, only attach the tow line to the tow eyes on the frame. There are tow eyes on the front of the frame and the rear of the frame. The front tow eyes are located at the front of the hydraulic tank compartment at the bottom. The rear tow eyes are located at the hitch point.Do not use a chain for pulling a disabled machine. A chain link can break.