KIT-REPAIR 3111217 - Caterpillar

Illustration 1 g02335416
Remove the pedal cover (1) .
Use the middle pedal (2) to set the brake light switch.
Illustration 2 g02337016
Loosen the locknut of the adjustment screw (3) for the brake light switch .
Illustration 3 g02337037
Place 0.015 0.002 mm (0.0006 0.0001 inch) shim tool (4) between the brake pedal stops on the pedal and the base as shown in Illustration 3Note: Prior to adjustments, if the brake lights are OFF, turn the adjustment screw (3) clockwise until the lights turn on and then proceed with Step 5.
Adjust the brake light switch adjustment screw (3). To adjust, turn the brake light switch adjustment screw (3) counterclockwise until the brake lights go off.
After adjustments, tighten the locknut of the adjustment screw (3) to 5.0 0.5 N m (44.3 4.4 lb in).
Remove the shim tool (4) between the brake pedal stops on the pedal and the base. Allow the pedal to return fully to the REST position.Note: If, the brake lights are ON, Refer Step 2, and readjust the brake light switch adjustment screw (3) .Throttle Lock Disconnect Switch Adjust
Use the following procedure to adjust the throttle lock disconnect switch:
Use the middle pedal (2) to set the throttle lock disconnect switch.
Illustration 4 g02337381
Place 0.020 0.002 mm (0.0008 0.0001 inch) shim tool (5) between the brake pedal stops on the pedal and the base.Note: Use CAT (ET) Electronic Technician tool to perform the throttle lock disconnect switch adjustments.
Illustration 5 g02337436
Loosen the locknut for the throttle lock brake switch adjustment screw (6) on the brake pedal and adjust. To adjust, turn the throttle lock brake switch adjustment screw (6) counterclockwise until the brake pedal