KIT-VALVE 3154331 - Caterpillar

Illustration 1 g00619083
Remove lip seal (1).
Illustration 2 g00619100
Use Tooling (A) to remove the sleeve bearing from the pin bore.
Repeat Steps 1 and 2 to remove the lip seal and the sleeve bearing from the other side of the stick.
Illustration 3 g01213578
Remove lip seals (2).
Illustration 4 g01213579
Use Tooling (A) to remove the sleeve bearing from the pin bore.
Repeat Steps 4 and 5 remove the lip seals and the sleeve bearing from the other side of the linkage assembly.
Illustration 5 g01213583
Remove lip seal (3) from the linkage assembly.
Illustration 6 g01213584
Use Tooling (A) to remove the sleeve bearing from the pin bore.
Repeat Steps 7 and 8 to remove the lip seal and the sleeve bearing from the other side of the linkage assembly.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
B 1P-0520 Bearing and Seal Driver 1
Illustration 7 g01214568
(X) Bucket control linkage
(Y) Sleeve bearing
Lower the temperature of the sleeve bearing. Use Tooling (A) to install the sleeve bearing in the linkage assembly. Install the sleeve bearing until Dimension (a) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the linkage assembly.
Illustration 8 g01214570
Use Tooling (A) to install lip seal (3). Install lip seal (3) with the sealing lip toward the outside of the linkage assembly. Install lip seal (3) until lip seal (3) contact with the sleeve bearing.
Repeat Steps 1 and 2 for the installation of the remaining lip seal and sleeve bearing.
Illustration 9 g01214571
(X) Bucket control linkage
(Y) Sleeve bearing
Lower the temperature of the sleeve bearing. Use Tooling (A) to install the sleeve bearing. Install the sleeve bearing until Dimension (b) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the linkage assembly.
Illustration 10 g01214572
Use Tooling (A) to install lip seals (2). Install lip seals (2) with the sealing lip toward the outside of the linkage assembly. Install lip seals (2) until lip seals (2) contact with the sleeve bearing.
Repeat Steps 4 and 5 for the installation of the remaining lip seal and sleeve bearing.
Illustration 11 g01214576
(Y) Sleeve bearing
(Z) Stick
Lower the temperature of the sleeve bearing. Use Tooling (A) to install the sleeve bearing in the stick. Install the sleeve bearing until dimension (c) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the stick.
Illustration 12 g01214574
Use Tooling (A) to install lip seal (1). Install lip seal (1) with the sealing lip toward the outside of the stick. Install lip seal (1) until lip seal (1) contact with the sleeve bearing.
Repeat Steps 7 and 8 for the installation of the remaining lip seal and sleeve bearing.End By:a. Install the bucket linkage.