KIT-SEAL 3240386 - Caterpillar

Illustration 1 g01159136
Schematic for the Automatic Blade Position Enable SwitchNote: The ABP enable switch is equipped on the 824H and the 826H model machines that have the Automatic Blade Position function.This diagnostic code is associated with the automatic blade position enable switch that is located on the armrest. The FMI 03 means that the ECM has determined that the voltage of the switch circuit is above normal.This switch has two inputs to the ECM. One input is normally open and one input is normally closed. The ECM activates this diagnostic code when both switch inputs are showing +battery voltage at the same time. This diagnostic code could also be activated if both inputs are open at the same time. During normal operation, one input is open and the other input is grounded.The possible causes of this diagnostic code are listed:
The switch has failed.
Short to the +battery circuit in the harness.
An open in the harness.
The ECM has failed. This is unlikely.System Response:The machine response is listed:
The ABP function will be disabled.Table 1 contains wire numbers and connector contacts. Use this information to troubleshoot the failed circuit.
Table 1
   
Switch
State Implement ECM
Connector Contact Number     Switch Contact     Wire Number     Status    
OFF     J1-25 "N/O" (1)     "N/O"     E962-YL     O (2)    
J1-26 "N/C" (3) "N/C"     E961-PK     G (4)    
ON     J1-25 "N/O"     "N/O"     E962-YL     G    
J1-26 "N/C" "N/C"     E961-PK     O    
( 1 ) Normally Open Position
( 2 ) Open
( 3 ) Normally Closed Position
( 4 ) GroundedNote: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code is active and that the diagnostic code indicator is active.Test Step 1. CHECK THE SWITCH
Turn the key switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the switch.
With the switch in the OFF position, measure the resistance of the switch contacts from the N.C. signal contact 1 to switch common contact 2.
With the switch in the OFF position, measure the resistance of the switch contacts from N.O signal contact 3 to switch common contact 2.
Move the switch to the ON position, and repeat Steps "C" and "D".Expected Result:When the enable switch is in the OFF position, the resistance measurement for Step "C" should measure less than 5 ohms (continuity). The resistance measurement for Step "D" should measure more than 5000 ohms (OPEN).When the enable switch is in the ON position the resistance measurement for Step "C" should measure less than 5000 ohms (open). The resistance measurement for Step "D" should measure less than 5 ohms (continuity).Results:
YES - All of the resistance checks for the switch are correct. The switch is working correctly. Proceed to Test Step 2.
NO - All of the resistance checks for the switch are NOT correct.Repair: The switch is faulty. Replace the switch. Stop.Test Step 2. CHECK