KIT- 3259470 - Caterpillar

3259470 KIT- Caterpillar parts

Price: query

Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3259470
325-9470
3259470

Weight: 0.27 pounds 0 kg.

Buy KIT- 3259470 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices:

As an associate, we earn commssions on qualifying purchases through the links below

1 X CATERPILLAR C7 ENGINE PISTON INFRAME - OVERHAUL REBUILD KIT NO CORE G122

$1,299.99

27 Nov 2019
47.0[21.15] Pounds
-: -

1 X CATERPILLAR C7 ENGINE PISTON INFRAME - OVERHAUL REBUILD KIT NO CORE G122
GOOD, CLEAN TAKE OUT || NO CORE EXCHANGE || MINOR COSMETIC BLEMISHES || 1969518 ,1969519 , 7W9415 , 2974835 , 3259472 , 3291383 , 2908676 , 2002258 , 3259470 , 2382698 , 1687224 , 7C0111 ,

Show more prices Caterpillar parts

For full view, you need register

Caterpillar SIS machinery equipment:

Caterpillar SIS

C7 On-highway Engine KAL00001-UP » 325-9470 KIT-GASKET

Information:

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
The 213-9100 Alarm As may fail on the machines listed above.Solution
Report the failure through the CPI feedback tool in Service Information Management System (SIMSi) referencing CPI number 403024 to have a "Send-It-Back" (SIB) request generated. A SIB request will be issued to your dealer code in the SIB system after the (SIMSi) entry is created.Perform the following Steps and record the observations before you replace the failed part:
Check the pin polarity and pin position in order to ensure that the pins do not get swapped.
Check the resistance from pin to pin.
Check for any physical damage to the housing, speaker and pig tail.
Illustration 1 g06291398
(1) Part label
Provide the picture of the part label. Refer to Illustration 1.
Report the symptoms such as no output, low output, chirp or other unusual noise.Replace the failed 213-9100 Alarm As with the same part number and perform the following Steps and record the observation:
Measure the output noise with a Decibel Meter.
Power the alarm assembly with a separate power supply and retest.Submit the failed component along with the recorded observations of before and after the replacement of the alarm assembly to (SIMSi):