KIT-GASKET 3268631 - Caterpillar

The emergency procedures in this section are intended as a way to return safely to the harbor. Some procedures may fix the problem and some procedures may be a temporary fix. Once the vessel is docked, ensure that any problems are properly corrected. The situations that are described do not cover all possibilities. The procedures are meant as a guideline for a safe return to the harbor.The Engine has Stopped
Follow the steps in order to restart the engine. The steps should eliminate the possible causes.
The fuel supply valve should be open.
Check the primary fuel filter (if equipped) and the fuel filters for restriction and for water. The vessel may be equipped with a water in fuel warning lamp. If the water in fuel warning lamp is illuminated, then there is water in the fuel system. The water must be removed before the engine is operated. Refer to the Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace" and the Operation and Maintenance Manual, "Fuel Tank Water and Sediment - Drain".
Check the amount of fuel in the fuel tank. There may be dirt or air in the fuel lines if the fuel level is extremely low or if the fuel level is empty. Refer to Operation and Maintenance Manual, "Fuel System - Prime".
If the engine will not start, disconnect the fuel shutoff solenoid on the fuel injection pump. Start the engine. The manual stop lever on the fuel injection pump must now be used to stop the engine. Refer to Operation and Maintenance Manual, "Manual Stop Procedure".There is a Reduction in Engine Power and Engine Speed
Follow the steps in order to determine the reason that the engine has lost power and speed.
Ensure that the propeller is free of debris.
Ensure that the air cleaner is not restricted. Ensure that the engine compartment has a good supply of air.
Check the primary fuel filter (if equipped) and the fuel filters for restriction and for water. The vessel may be equipped with a water in fuel warning lamp. If the lamp is illuminated, then there is water in the fuel system. The water must be removed before the engine is operated. Refer to the Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace" and Operation and Maintenance Manual, "Fuel Tank Water and Sediment - Drain".The Engine is Overheating
Follow the steps in order to correct the overheated engine.
Reduce the engine speed to low idle. Stop the engine. Check for leaks and for steam. Allow the engine to cool.
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure.
Check the coolant level. Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check".
Check the valve for the sea water. Ensure that the valve for the sea water is open. Check the sea water strainer for debris. Ensure that the valve for the sea