KIT-TORQUE CONVERTER BEARING 3398223 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     1    
B     -     Guide Bolt
M12 - 1.75 by 120 mm     1    
Illustration 1 g01152630
Attach Tooling (A) and a suitable lifting device to flywheel (2). The weight of flywheel (2) is approximately 27 kg (60 lb).
Remove top bolt (1). Install Tooling (B). Remove remaining bolts (1) .
Remove flywheel (2) from Tooling (B).
Replace ring gear (3), if necessary. Use a hammer and a punch in order to remove the flywheel ring gear.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     1    
B     -     Guide Bolt
M12 - 1.75 by 120 mm     1    
C     9S-3263     Thread Lock Compound     1    
Illustration 2 g01152630
Raise the temperature of ring gear (3) .Note: Do not use a torch to heat the ring gear.
Position ring gear (3) on flywheel (2) with the part number toward the crankshaft. Use a soft hammer in order to seat the ring gear against the shoulder of the flywheel. Allow the ring gear to cool.
Install Tooling (B) in the crankshaft.
Attach Tooling (A) and a suitable lifting device to flywheel (2). The weight of flywheel (2) is approximately 27 kg (60 lb).
Position flywheel (2) on Tooling (B) .
Apply Tooling (C) to the threads of bolts (1) .
Install bolts (1). Remove Tooling (B) and install remaining bolt (1) .
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".