KIT-SEAL 3417128 - Caterpillar

Normal Mode
The AccuGrade system automatically operates in normal mode when you start-up the display. Turn the key start switch to ON and press the power key.As a default, the following soft keys are available when the display is in normal mode.
Select blade tip focus ("Blade: Left or Blade: Right")
Set the horizontal offsets ("H. Offset.")
Set the vertical offsets ("V. Offset.")
Turn map recording on or off (if enabled)
Set the GPS accuracyYou can also use the "Setup Menu – Configuration" dialog to perform the following when you are in Normal mode.
Select Design
Bench (Laser and Sonic only)
Vertical Offset
Horizontal Offset
GPS Accuracy
Edit the Blade Wear value
Vertical Setup
Set the Light Bar Scales and On-Grade Tolerance
Display and Lightbar Brightness
Calibrate Sensors
Set the Valve Speed
Restore the Display Settings or the Machine Settings
View basic Diagnostic informationRefer to the Operation and Maintenance Manual, SEBU8283 for more details on Normal mode operation.Service Mode
Note: If you lack experience with the AccuGrade system, use extreme care when you are in service mode so that you do not accidentally change the settings of the AccuGrade system.Service mode allows you to have access to all available options that the AccuGrade system offers.Use service mode in order to change the settings that affect the operation of the AccuGrade system.In order to turn on service mode, turn off the display if the display is ON. Press and hold down the "OK" key as you press the power key. Hold down the "OK" key until the display shows the start-up screen.In order to turn off service mode, turn off the display.Use the "Setup Menu - Configuration" dialog in order to perform the following when you are in service mode:
Select Design
Bench (Laser and Sonic only)
Vertical Offset
Horizontal Offset
GPS Accuracy
Blade Wear
Vertical Offset Increment Switch
Lightbar Scales
Display and Lightbar Brightness
Map recording
Valve Speed
Calibrate Sensors
Adjust Bolt Hole
Avoidance Zones
Text items
Plan View Rotation
ST300C Connections
Beeper Configuration
Save Settings
Restore Settings
GPS Receiver Configuration
DiagnosticsUse the "Setup Menu - Installation" dialog to perform the following when you are in Service Mode:
Machine Settings
Set Units
Set machine Dimensions
Set the Radio Network
Light Bar Connections
Valve Calibration
Turn on Wireless Communication Support
Turn on Production Recording
Upgrade Firmware
Operator Configuration
Software Option
Enter Software Support Option
Guidance Hours
Select LanguageTurn the off the display in order to exit service mode after you edit the settings or perform tests on the GPS receiver. This ensures that inexperienced users will not inadvertently change the settings of the AccuGrade system.