KIT-HYD CYLINDER SEAL 3446336 - Caterpillar

Illustration 1 g01672334
Apply Tooling (F) on the face of the sealing ring, yoke (19), and shaft splines.
Apply Tooling (G) to the threads of bolt (20).
Position yoke (19) and install bolt (20). Tighten bolt (20) to a torque of 530 70 N m (391 52 lb ft).
Illustration 2 g01672259
Attach Tooling (B), Tooling (C), and Tooling (D) to generator (18). The weight of generator (18) is approximately 4763 kg (10,500 lb).
Alternatively, attach Tooling (E) onto generator (18). The weight of generator (18) is approximately 4763 kg (10,500 lb).
Position generator (18) into the machine.
Illustration 3 g01672136
Illustration 4 g01672135
Install bolt (17) and the nut. Tighten bolt (17) to a torque of 1800 200 N m (1328 148 lb ft). Repeat for the other side.
Position mount (16) and install the bolts. Repeat for the other side.
Illustration 5 g01668497
Illustration 6 g01668496
Install bolts (15). Tighten bolts (15) to a torque of 1000 125 N m (738 92 lb ft).
Remove Tooling (A) and the suitable lifting device from shaft (14).
Illustration 7 g01668373
Install plates (12) and (13).
Illustration 8 g01668353
Connect cable assembly (11).
Illustration 9 g01668299
Position duct assembly (10) and install bolts (9).
Illustration 10 g01668237
Position duct assembly (7) and install bolts (6).
Connect harness assembly (8).
Illustration 11 g01668233
Illustration 12 g01668034
Install clamp (5) in order to position harness assemblies (3).
Install bolts (2). Tighten lock washers (4).
Illustration 13 g01667893
Install cover (1).End By:
Remove the retaining cable and lower the truck body. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".