KIT-GASKET 3492894 - Caterpillar

Illustration 1 g00298498
(A) Extension test (B) Retraction test
Fully retract the bucket cylinder and the stick cylinder.
Position the bucket on the ground. With a stopwatch, measure the time that is required to fully extend the boom cylinders.
Position the boom cylinders at full extension. With a stopwatch, measure the time that is required for the bucket to come in contact with the ground.
Refer to the specifications in Table 1 for the operating speed of the boom cylinders.
Perform the following steps in order to test the operating speed of the stick cylinder.
Start the engine.
Place the hydraulic activation control lever in the UNLOCKED position.
Place the machine on level ground.
Place the machine controls at the following settings: Engine speed dial "10" and Low idle switch OFF.
The bucket should be empty.
Illustration 2 g00298558
(A) Extension test (B) Retraction test
Position the upper surface of the boom parallel to the ground.
Fully extend the bucket cylinder.
Retract the stick cylinder. With a stopwatch, measure the time that is required to fully extend the stick cylinder.
Extend the stick cylinder. With a stopwatch, measure the time that is required to fully retract the stick cylinder.
Refer to the specifications in Table 1 for the operating speed of the stick cylinder.
Perform the following steps in order to test the operating speed of the bucket cylinder.
Start the engine.
Place the hydraulic activation control lever in the UNLOCKED position.
Place the machine on level ground.
Place the machine controls at the following settings: Engine speed dial "10" and Low idle switch OFF.
The bucket should be empty.
Illustration 3 g00298598
(A) Extension test (B) Retraction test
Position the upper surface of the boom parallel to the ground.
Position the stick so that the stick is perpendicular to the ground.
Fully retract the bucket cylinder.
With a stopwatch, measure the time that is required to fully extend the bucket cylinder.
Position the bucket cylinder at full extension. With a stopwatch, measure the time that is required to fully retract the bucket cylinder.
Refer to the specifications in Table 1 for the operating speed of the bucket cylinder.
Table 1
Cylinder Operating Speed (seconds)    
Item    New    Rebuild    Service Limit    
Boom     Extension     3.6 0.5     4.7 (1)     5.4 (1)    
Retraction 2.9 0.5     3.8 (1)     4.4 (1)    
Boom (2)     Extension     2.6 0.5     3.4 (1)     3.9 (1)    
Retraction 2.1 0.5     2.7 (1)     3.2 (1)    
Stick     Extension     3.0 0.5     3.9 (1)     4.5 (1)    
Retraction 2.3 0.5     3.0 (1)     3.5 (1)    
Bucket     Extension     4.2 0.5     5.5 (1)     6.3 (1)    
Retraction 2.8 0.5     3.6 (1)     4.2 (1)    
( 1 ) Maximum
( 2 ) Machines with a swing boom