KIT-SEAL 3560827 - Caterpillar

Illustration 1 g02573156
Illustration 2 g02573158
View H-H
(3) Location pin for correct installation of connecting rod caps
Table 1
Specification for 381-6555 Rod As
Item Qty Part Specification Description
Angle (A) above the centerline on either side of the bearing joint for the sleeve bearing for the piston pin is 10 degrees.
The connecting rod may be heated from 175 to 260 °C (347 to 500 °F) for the installation of the bearing for the piston pin. Minimum length (B) for heating the connecting rod is 105 mm (4.1 inch). Do not use a torch to heat the connecting rod.
C 1 377-5237 Bearing Thoroughly lubricate the piston pin with clean engine oil prior to assembly of the piston and the connecting rod.
Bore in the bearing for the piston pin after installation of the bushing is 70.000 0.008 mm (2.7559 0.0003 inch).
Bore in the connecting rod for the bearing is 75.760 0.015 mm (2.9827 0.0006 inch).
D - - Distance between the center of the bearings is 392.5 mm (15.45 inch).
E 1 7N-2043 Dowel Protrusion of the dowel from the connecting rod cap is 4.0 0.5 mm (0.16 0.02 inch).
F - - Bore in the connecting rod for the bearing for the crankshaft connecting rod journal after applying final torque to the connecting rod bolts is 143.028 0.015 mm (5.6310 0.0006 inch).
G - - Bore in the connecting rod bearing for crankshaft is 135.133 to 135.194 mm (5.3202 to 5.3226 inch).
1 - - Etch the cylinder number on the connecting rod and the cap in this location. Mark the connecting rod and the cap with numbers. Mark the numbers on the same side of the connecting rod as the bearing retainer notch.
2 - - The chamfer side must be next to the crank pin thrust surface when the connecting rod and piston group is assembled in the engine.
- 4 7N-2405 Bolt Use the following procedure for tightening the connecting rod bolts:
Bolt 1 and bolt 2 must be on the same end of the connecting rod cap that has bearing tabs and location pin (3).
1. Before assembly, apply Molylube on the bolt threads, the bolt shank, and the bolt seat.
2. Sequentially tighten the bolt 1 and bolt 2 to 90 5 N m (66 4 lb ft).
3. Sequentially tighten the bolt 3 and bolt 4 to 90 5 N m (66 4 lb ft).
4. Again, sequentially tighten the bolt 3 and bolt 4 to 90 5 N m (66 4 lb ft).
5. Tighten all bolts for an additional angle of 90 5 degrees.