KIT-GASKET 3612578 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00753827
Remove bolts (1) and remove cover (2) from the engine.
Illustration 2 g00753826
Loosen bolt (3) on bracket (4) that holds alternator (5) .
Illustration 3 g00805048
Loosen tension adjustment bolts (6) and slide the alternator toward the engine. Remove the V-belt.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 4 g00805048
Install the V-belt onto the alternator pulley and onto the crankshaft pulley.
Slide the alternator away from the engine. Tighten tension adjustment bolt (6) .
Illustration 5 g00753826
Tighten bolt (3) on bracket (4) that holds alternator (5) .Note: Refer to the Specifications, "Belt Tension Chart" for the correct belt tension.Note: If the V-belt cannot be checked with a gauge, press on the V-belt at the center of the longest free length in order to check the deflection. Under a moderate amount of pressure, the V-belt should have a deflection of 10.0 mm (0.40 inch).
Illustration 6 g00753827
Install cover (2) onto the engine. Tighten two bolts (1) .