KIT-HOUSING 3613945 - Caterpillar

Crushing Hazard! Stay clear of the boom when the machine is in operation. Failure to stay clear of the swinging boom could cause serious injury or death.
High Pressure Cylinder (9)This safety message is located on the inside surface of the access plate for the track adjusters.
Illustration 11 g01371642
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for the proper service procedure.Jump Start Cables (10)This safety message is located next to the battery.
Illustration 12 g01370909
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Refer to Operation and Maintenance Manual, "Engine Starting with Jump Start Cables" for further information.Crushing Hazard (11)This safety message is located on both sides of the rear of the machine.
Illustration 13 g01382702
Machine swings. Stay back. Crushing hazard could cause serious injury or death.
Rotating Fan (12)This safety message is located near the engine fan.
Illustration 14 g02793868
Cutting Hazard! Keep hands clear of fan while engine is running. May cause serious injury or death.
High Pressure Gas (13)This safety message is located on the accumulator.
Illustration 15 g03336117
Pressurized System!Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas pre-charge must be removed from the accumulator as instructed by the service manual before servicing the accumulator or any accumulator component.Failure to follow the instructions and warnings could result in personal injury or death.Only use dry nitrogen gas to recharge accumulators. See your Cat dealer for special equipment and detailed information for accumulator service and charging.
Refer to Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped" for further information.Pressurized System (14)This safety message is located on the inside of the hood next to the cooling system filler cap.
Illustration 16 g01371640
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check" for further information.