KIT-CONTROL VALVE 3784713 - Caterpillar

Illustration 1 g01874113
Suspension cylinder pressure sensor circuit
CID 0841 identifies the right rear strut pressure sensor. The output frequency of the sensor changes as the pressure in the suspension cylinder changes. The sensor is powered by the machine electrical system.Note: In addition to the “Suspension Cylinder Pressure Sensor” troubleshooting procedure, the VIMSTM diagnostics are helpful in troubleshooting sensors.Use this procedure to troubleshoot the suspect performance of suspension cylinder pressure sensors or any failure that is associated with the suspension cylinder pressure sensors.Note: This test checks for sensor voltages at the sensor when all the circuits are connected. Unless you are directed otherwise, do not disconnect any components. Troubleshoot the circuit “as is” before disconnecting any circuits.
Table 1
Tools Needed
9U-7330 or Equivalent Calibrated Multimeter
7X-1710 Multimeter Probe Before beginning the test procedure:
Locate the suspect sensor.
Identify the sensor wires and connector contacts.
Do not disconnect the harness connectors at this time.
Turn the key start switch to the ON position.
The truck can be empty or the truck can be loaded.Test Step 1. CHECK THE SENSOR SUPPLY VOLTAGE
At the sensor connector, identify:
The +V circuit
The ground circuits
Insert the 7X-1710 Multimeter Probe leads into the back of the