KIT-SEAL 3945556 - Caterpillar

Governor Transient Response Loop Gain Percentage
This parameter will allow the loop gain percentage to be set somewhere between 10 - 1000 %.Customer Password #1
This parameter allows the customer to lock out certain parameters by entering a password. Customer passwords must be used to unlock any parameters that are protected by customer passwords before the parameter can be changed. Factory passwords are required if this password is lost.Customer Password #2
This parameter allows the customer to lock out certain parameters by entering a password. Customer passwords must be used to unlock any parameters that are protected by customer passwords before the parameter can be changed. Factory passwords are required if this password is lost.Total Tattletale
The total tattletale counts the number of changes to system parameters.Parameter Table
Table 2
System Configuration Parameters
Parameter Default Range Password
Required
"Rating Number" Software Dependent Software Dependent No
"Rated Power" Software Dependent Software Dependent Read Only
"Rated Peak Torque" Software Dependent Software Dependent Read Only
"Top Engine Speed Range" Software Dependent Software Dependent Read Only
"Equipment ID" 00000000000000000 17 alphanumeric numbers Customer
"Engine Serial Number" 00000000 8 alphanumeric numbers Factory
"ECM Serial Number" Hardware Dependent Hardware Dependent Read Only
"Software Group Part Number" Software Dependent Software Dependent Read Only
"Software Group Release Date" Software Dependent Software Dependent Read Only
"Software Group Description" Software Dependent Software Dependent Read Only
"Full Load Setting (FLS)" 0 -128 to +127 Factory
"Full Torque Setting (FTS)" 0 -128 to +127 Factory
"Low Idle (rpm)" 0 −25 to 0 Customer
"Exhaust Temperature Sensor Installation Status" Not Installed Installed
Not Installed Customer
"Secondary Engine ECM Function Configuratio" Governor Control Governor Control
Marine Alarm & Protection (MA&P)
MA&P and Governor Control Customer
"Engine Acceleration Rate (rpm/s)" 250 200 to 600 Customer
"Engine State Control Input Configuration" Hardwired Input CAN Input
Hardwired Input Customer
"Engine State Control Secondary Input Configuration" Not Installed