KIT-LEVEL SENDER 3951087 - Caterpillar

Probable Causes
Active engine shutdown
Electrical connectors
Circuit breakers
Engine speed/timing
Fuel supply
Cat data linkRecommended Actions
Active Engine Shutdown
Use Caterpillar Electronic Technician (ET) to check for active engine shutdowns and/or logged engine shutdowns. Determine the reason for any shutdowns. After correcting the problem, cycle the keyswitch to the OFF/RESET position for at least 15 seconds before you try to restart the engine.Electrical Connectors
Check for correct installation of ECM connectors J1/P1 and J2/P2, machine connector J3/P3, and the engine speed/timing sensor connectors. Refer to Troubleshooting, "Electrical Connectors - Inspect".
Use Cat ET to check for the following logged diagnostic codes: 168-01 and 168-02. If either of these diagnostic codes are logged, proceed to Troubleshooting, "Electrical Power Supply Circuit - Test".
Inspect the battery wires from the Electronic Control Module (ECM) back to the battery compartment. Refer to the Electrical System Schematic. Inspect the wires and the power relay. Check the power and ground connections to the ECM. Refer to Troubleshooting, "Electrical Power Supply Circuit - Test" for more information.Circuit Breakers
Check the circuit breakers on the machine. The circuit breakers may exceed the trip point due to overheating. Reset the circuit breakers if the circuit breakers are tripped.Engine Speed/Timing
Use Cat ET to check for logged diagnostic codes for the engine speed/timing sensors. Refer to Troubleshooting, "Engine Speed/Timing Sensor Circuit - Test" for more information.Fuel Supply
Check the fuel lines for the following problems: restrictions, collapsed lines and pinched lines. If problems are found with the fuel lines, repair the lines and/or replace the lines.
Check the fuel tank for foreign objects which may block the fuel supply.
Check for air in the low pressure fuel supply system if any of the following procedures have been performed:
Replacement of the fuel filters
Service on the low pressure fuel supply circuit
Replacement of unit injectorsNote: A sight glass in the low pressure supply line is helpful in diagnosing air in the fuel. Refer to Testing and Adjusting for more information.
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again.
Purge air from the low pressure fuel supply circuit. Refer to Operation and Maintenance Manual, "Fuel System - Prime" for the correct procedure.
Check fuel quality. In temperatures below 0 °C (32 °F), check for solidified fuel (wax). Refer to Special Instruction, SEBD0717, "Diesel Fuels And Your Engine".
Check the fuel pressure after the fuel filter while the engine is being cranked. Refer to Testing and Adjusting for the correct pressure values. If the fuel pressure is low, replace the fuel filters. If the fuel pressure is still low, check the following items: fuel transfer pump, fuel transfer pump coupling and fuel pressure regulating valve. Refer to Testing and Adjusting for more information.Cat Data Link
Troubleshoot the Cat data link for possible problems. Refer to Troubleshooting, "CAT Data Link Circuit - Test".