KIT-SEAL 4197879 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Bolt
(M16 x 2 by 4 inch) 1
B 138-7573 Link Bracket 1
C FT-2711 Special Bolt 2
D 9S-3263 Thread Lock Compound 1
Raise the temperature of the flywheel ring gear. Do not use a torch to heat the flywheel ring gear. Install the flywheel ring gear on the flywheel. Position the flywheel ring gear with the part number toward the crankshaft. Allow the flywheel ring gear to cool. Use a soft hammer in order to seat the flywheel ring gear against the shoulder of the flywheel.
Illustration 1 g01138041
Attach Tooling (B) and a suitable lifting device to flywheel (2). The weight of flywheel (2) is approximately 40 kg (85 lb).
Position flywheel (2) on Tooling (A).
Apply Tooling (D) to the threads of bolts (1). Note: Tooling (C) should be removed at this time, if Tooling (C) was used in the removal procedure for the flywheel.
Install bolts (1). Remove Tooling (A) and install remaining bolt (1). Tighten the bolts evenly to a torque of 300 40 N m (221 30 lb ft).
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".