KIT-FRONT COVER GASKET 4239426 - Caterpillar

Illustration 1 g00704000General
All fuels, most lubricants, and some coolant mixtures are flammable.To minimize the risk of fire or explosion, Caterpillar recommends the following actions.Always perform a Walk-Around Inspection, which may help you identify a fire hazard. Do not operate a machine when a fire hazard exists. Contact your Cat dealer for service.Do not operate a machine with a fluid leak. Repair leaks and clean up fluids before resuming machine operation. Fluids that are leaking or spilled onto hot surfaces or onto electrical components can cause a fire. A fire may cause personal injury or death.Remove flammable material such as leaves, twigs, papers, and trash. These items may accumulate in hot areas and hot parts on the machine.Clean all accumulations of flammable materials such as fuel, oil, and debris from the machine.Do not operate the machine near any flame.Keep shields in place. Exhaust shields (if equipped) protect hot exhaust components from oil spray or fuel spray in a break in a line, in a hose, or in a seal. Exhaust shields must be installed correctly.Do not weld or flame cut on tanks or lines that contain flammable fluids or flammable material. Empty and purge the lines and tanks. Then clean the lines and tanks with a nonflammable solvent prior to welding or flame cutting. Ensure that the components are properly grounded to avoid unwanted arcs.Dust that is generated from repairing nonmetallic hoods or fenders may be flammable and/or explosive. Repair such components in a ventilated area away from open flames or sparks. Use suitable Personal Protection Equipment (PPE). Inspect all lines and hoses for wear or deterioration. Replace damaged lines and hoses. The lines and the hoses should have adequate support and secure clamps. Tighten all connections to the recommended torque. Damage to the protective cover or insulation may provide fuel for fires.Store fuels and lubricants in properly marked containers away from unauthorized personnel. Store oily rags and flammable materials in protective containers. Do not smoke in areas that are used for storing flammable materials.Wiring
Check electrical wires daily. If any of the following conditions exist, replace parts before you operate the machine.
Fraying
Signs of abrasion or wear
Cracking
Discoloration
Cuts on insulation
Other damageMake sure that all clamps, guards, clips, and straps are reinstalled correctly. This will help to prevent vibration, rubbing against other parts, and excessive heat during machine operation.Attaching electrical wiring to hoses and tubes that contain flammable fluids or combustible fluids should be avoided.Consult your Cat dealer for repair or for replacement parts.Keep wiring and electrical connections free of debris.Lines, Tubes, and Hoses
Do not bend high-pressure lines. Do not strike high-pressure lines. Do not install any lines that are bent or damaged. Use the appropriate backup wrenches to tighten all connections to the recommended torque.
Illustration 2 g00687600Check lines, tubes, and hoses carefully. Wear Personal Protection Equipment (PPE) to check for leaks. Always use a board or cardboard when you check for a leak. Leaking fluid that is under pressure can penetrate body tissue. Fluid penetration can cause serious injury and possible death.