KIT-TRANSMISSION BEARING 4433635 - Caterpillar

Table 1
Status    Contact    
Pin 1 Pin 2    Pin 3    Pin 4    Pin 5    
Closed to Ground
(5110B) (1)     No     No     Yes     Yes     No    
Closed to Ground
(5110B) (2)     Yes     Yes     No     No     Yes    
Closed to Ground
(5110B) (3)     Yes     No     Yes     Yes     Yes    
( 1 ) ME, FS and Bucket Thumb configurations.
( 2 ) GP with Bucket and Shear/Hammer configurations.
( 3 ) Work Tool/Magnet configuration.If the harness code is invalid at powerup, a CID 0650 FMI 02 will be logged and the application will look for a valid harness code that was previously stored in the ECM. If no valid code was found in the ECM, the application will not run. If there is a valid harness code that is stored in the machine ECM, the application will run by using the previously stored harness code.Configurable Parameters
ME, FS and Bucket Thumb
Table 2
Parameter Name     Selectable Options     Dependencies    
Bucket Configuration Status     Mass Excavator     None    
Bucket Thumb
Front Shovel
Autolube System
Installation Status     Installed     None    
Not Installed
Reel Lube
Installation Status     Installed     None    
Not Installed Independant of autolube system    
Autolube Interval     5 to 30 minutes     Will say Not Available when the installation status of the Autolube System is "Not Installed" or "Not Configured". When the autolube system is changed to Installed from "Not Configured" or "Not Installed", then the values will reset to the default value of 5 minute interval and 90 second duration.    
Not Available
Autolube Duration
    90 to 120 seconds    
Not Available
Left Ladder
Installation Status     Installed     None    
Not Installed
Hydraulic Cooling Fan Map     Standard Map Selection     None
The parameter will default to the standard map.
Not Configured is NOT an option