KIT-FRONT COVER GASKET 4440531 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00784950
(1) Bolt (2) 8T-9655 Mount (3) Spacer (4) 190-8970 Base As (5) Mounting surface (6) 9N-0869 Hard Washer (7) 6V-8189 Nut Determine an appropriate location in order to mount the pump. Refer to Illustration 1. A template is provided for the mounting holes. The template is located at the end of this instruction. Use a 9 mm (0.354 inch) drill bit for the mounting holes. Use the bolts, nuts, spacers and mounts that are provided to attach the filter base to the machine. The mounting location for the fuel priming pump will be determined by the application. Ensure that the fuel priming pump is located in an area that can be serviced easily. Ensure that you have access to the 6V-8189 Nut when the 190-8970 Base As is attached to the machine. Ensure that the fuel priming pump is located away from electrical components. Ensure that the fuel priming pump is located away from debris and all hot surfaces. The electrical circuit for the fuel priming pump must have an in-line 5 amp fuse. The electrical circuit for the fuel priming pump must have a spring loaded activation switch. The spring loaded activation switch must have a factory default setting to the OFF position. Route the wires for the fuel priming pump away from rubbing or chafing surfaces. The activation switch should be mounted within reach of the ignition switch. The activation switch should be disabled when the ignition switch is in the OFF position. The diameter of the fuel hose will be determined by the application. The size of the fuel fittings will be determined by the application. The fuel hose should be capable of a minimum rating of 2068.5 kPa (300 psi). The fuel hose must be routed away from electrical components and away from hot surfaces. The fuel hose must be routed away from rubbing and away from chafing surfaces.Typical Electrical Diagram
Illustration 2 g00781973
(1) Base assembly (2) Electrical connector (3) Activation switch for priming pump (4) Fuse holder (5 amp) (5) Ignition switch (6) 24 volt batteryUse Illustration 2 as a reference in order to install the wiring. Typical Diagram for the Plumbing
Illustration 3 g00924871
This illustration is effective with all of the engine models that are below the 3500 Engines. (1) Injector (2) Fuel pressure regulator (3) Fuel tank (4) Primary fuel filter (5) Fuel pump (6) Fuel priming pump (7) Secondary fuel filter (8) Fuel supply rail
Illustration 4 g00782023
This illustration is effective with all of the 3500 Engines and up. (1) Injector (2) Fuel pressure regulator (3) Fuel tank (4) Primary fuel filter (5) Fuel pump (6) Fuel priming pump (7) Secondary fuel filter (8) Fuel supply railHose Installation
Illustration 5 g00783289
Left side view (A) Fuel outlet (B) Fuel inlet
Illustration 6 g00783314
Right side view (A) Fuel outlet (B) Fuel inlet Two inlet connections and two outlet connections are located on the base of the pump. Refer to