KIT-CYLINDER HEAD REPAIR 4529918 - Caterpillar

6. Remove spiral snap ring (4) and washer (5) from the shaft.7. Remove two bolts (6) and install two 1/2"-13 NC forged eyebolts. 8. Fasten a hoist to the torque converter (7). Remove nuts (8) that hold the torque converter to the number one clutch housing. Remove the torque converter. Weight is 156 lb. (71 kg).Install Torque Converter
1. Fasten a hoist and install the torque converter on the number one clutch housing.2. Install the nuts that hold the torque converter to the clutch housing. 3. Remove the two eyebolts and install the two bolts (3) in their place. Tighten the two bolts that were removed to a torque of 81 4 lb.ft. (109.8 5.4 N m).4. Install washer (1) and spiral snap ring (2) on the shaft. 5. Fasten a hoist and install transmission case (4) in its original position.6. Install the bolts that hold the number one and five clutch housings to the transmission case.7. Remove the transmission from tool (A). end by:a) install transfer gearsb) install transmission hydraulic control valvesc) install transmissionDisassemble Torque Converter
start by:a) remove transmissionb) remove torque converter 1. Remove spiral snap ring (1) and support (2) from the torque converter. The bearing can not be removed from the support. 2. Remove the bolts that hold impeller (3) to the housing. Use two 3/8"-16 NC forcing screws to make a separation of the impeller and housing.3. Remove the impeller from the housing. 4. Remove the bolts and plate that hold hub (4) to the impeller. Remove the hub from the impeller. 5. Remove carrier (5) and the stator as a unit from the turbine hub. 6. Remove seal (6) from the carrier.7. Remove race (7) and bearing (8) from the carrier. 8. Remove ring (9) and plate (10) from stator (11).9. Turn carrier and stator over. Hold the stator and turn carrier in a clockwise direction to release the one-way clutch. Pull the carrier out of the stator. The rollers and springs for the clutch will fall out of the stator as the carrier is removed. Remove cam (14) only if a replacement of the cam or stator is to be made. 10. Remove ring (12) and plate (13) from stator (11).11. Heat the stator and cam to a temperature of 300°F (149°C) for five minutes only. Remove cam (14) from the stator with a press while it is hot. 12. Remove bearing (16) from carrier (5).13. Remove bearing (15) from carrier (5). 14. Remove hub (17) and the turbine as a unit. 15. Remove bearing (18) and the race under bearing (18) from the hub. 16. Remove race (20) from the hub.17. Remove bolts (19) that hold turbine (21) and the ring to the hub. Remove the turbine from the hub. 18. Remove bearing (22) and the race under bearing (22) from the flange. 19. Turn housing (23) over and remove the bolts that hold flange (24) to the housing.20. Install two 1/2"-13 NC forcing screws in the flange and remove