KIT-ENGINE GASKET 4549091 - Caterpillar

Illustration 1 g01180011
(1) Auxiliary start receptacleThere are two cable assemblies that can be used to jump start the stalled machine. You can jump start the stalled machine from another machine that is equipped with an auxiliary start receptacle or with an auxiliary power pack. Your dealer can provide the correct cable lengths for your application.
Determine the reason that the engine will not start.
Lower all work tools to the ground.
Turn the start switch key on the stalled machine to the OFF position. Turn off all accessories.
Turn ON the battery disconnect switch on the stalled machine.
Move the machine that is being used as a power source close to the stalled machine. The jump start cables should reach the batteries on both machines. DO NOT ALLOW THE MACHINES TO CONTACT EACH OTHER.
Stop the engine on the machine that is being used as a power source. If you use an auxiliary power source, turn off the charging system.
Connect the appropriate jump start cable to auxiliary start receptacle (1) on the stalled machine.
Connect the other end of the jump start cable to the auxiliary start receptacle of the machine that is being used as a power source.
Start the engine on the machine that is being used as a power source or energize the charging system on the auxiliary power source.
Allow the machine that is being used as a power source to charge the batteries for two minutes.
Attempt to start the stalled engine.
Immediately after the stalled engine starts, disconnect the jump start cable from the power source.
Disconnect the other end of the jump start cable from the stalled machine.
Conclude the failure analysis on the starting charging system of the stalled machine, as required. Check the machine while the engine is running and the charging system is in operation.