KIT- 4559522 - Caterpillar

Above 60°F (16°C)
7. Push in and turn HEAT-START switch to START ... 8. ... release switch as soon as engine starts.Below 60°F (16°C)
7. Push in and turn HEAT-START switch to HEAT for indicated time (see Starting Aid Chart). 8. Push in and turn HEAT-START switch to START ... 9. ... release switch as soon as engine starts.10. When engine starts it may be necessary to return HEAT-START switch to HEAT until engine runs smoothly.
Never turn disconnect switch OFF when engine is running.
When Starting Fluid Is Required
7. Push in and turn HEAT-START switch to HEAT for indicated time (see Starting Aid Chart). 8. Push in and turn HEAT-START switch to START ...... and discharge starting aid capsule or spray starting fluid sparingly into precleaner while cranking.
Use starting fluid sparingly. Follow manufacturer's instructions carefully.
9. When engine starts it may be necessary to return HEAT-START switch to HEAT until engine runs smoothly.
If engine again does not start, let starter cool 2 minutes then repeat starting procedure.
Attach ground cable last, and remove first, to prevent sparks from occurring near the battery which could cause battery vapors to explode. Attach ground cable from booster battery to frame of machine to be started at a point away, and below the battery on the machine to be started.
When using jumper cables, be sure to connect in parallel: POSITIVE (+) to POSITIVE (+) and NEGATIVE (-) to NEGATIVE (-).