KIT-ENGINE GASKET 4599934 - Caterpillar

4599934 KIT-ENGINE GASKET Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4599934
459-9934
4599934

Weight: 0.100 pounds 0 kg.

Buy KIT-ENGINE GASKET 4599934 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Caterpillar 3412 Central & Lower Structure Gasket Kit (4599934)

$53.10

20 Mar 2018
201 Hundredths Pounds
CTP: CTP

Caterpillar 3412 Central & Lower Structure Gasket Kit (4599934)
4599934 Caterpillar, Engine Parts Weight(lbs): 2.00

Show more prices Caterpillar parts

This part in 2 request: Show. This information for suppliers only!

#1418086 459-9934

2024-09-05

#1418001 459-9934

2024-09-05

For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8T-2998 Lubricant 1 Start By:
Remove the valve mechanism cover.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Put identification marks on each of the rocker arms and push rods in order to identify the proper location for installation.
Illustration 1 g02150943
Disconnect harness assemblies (4). Note: Failure to hold stud bolt (2) stationary during the removal of nut (1) could result in damage to the harness assembly (3).
Hold stud bolts (2) with a wrench in order to keep the stud bolts from rotating. Remove nuts (1). Position harness assembly (3) out of the way.
Illustration 2 g02150968
Loosen nuts (6) and loosen rocker arm adjustment screws (5).
Remove bolts (8) and remove stud bolts (2). Remove the rocker arm shaft assembly.
Remove pushrods (7). Installation Procedure
Install the rocker arm shaft assembly in the reverse order of removal.
Apply Tooling (A) to both ends of the pushrods.
Apply Tooling (A) to each of the bottom faces of the rocker arms.
Illustration 3 g01943645
Illustration 4 g02151190
View showing stud bolt (2) locations.
Align the rocker arm shaft assembly with locating dowel (X).
Adjust the valve lash of the rocker arms. Refer to Testing and Adjusting, "Engine Valve Lash - Inspect/Adjust".