KIT-GASKET (T) 4626451 - Caterpillar

Illustration 5 g01262909
Press "OK". Raise the blade to near the maximum height. Measure the distance from the left blade tip to the same point on the ground. Enter this measurement in the Blade Elevation dialog that is represented in Illustration 5.
Press "OK".Proceed to Step 10.
Illustration 6 g01114784
Raise the blade to the maximum height. Press "OK". The dialog that is shown in Illustration 6 appears.You are prompted to move the blade to the bottom of the blade's range of lift. The "Current pitch" reading decreases.
Press "OK".This information is used in order to calculate the angle that the blade has moved through a full range of lift with respect to the blade pivot point.
Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
A message appears warning you that the valve calibration will cause the blade to start moving. Press "OK" in order to continue the calibration. Press the "ESC" key in order to cancel the calibration.A message appears telling you to make sure the Auto/Manual remote switch is set to "Auto".
Illustration 7 g01114787
Press "OK". The lift valve calibration will start.Note: Press the "Manual" button in order to stop the calibration procedure.A progress bar that shows the progress of