KIT- 4641068 - Caterpillar

General Maintenance and Care for the Masts
Inspection and Cleaning
Inspect and clean the masts of the AccuGrade system when the masts are removed from the machine or when the masts are serviced. Use the list that follows in order to inspect the masts and clean the masts.
Check the connectors for corroded contacts or dirty contacts.
Check the connectors for stripped threads or otherwise damaged threads.
Check the lead screw assembly of the inner mast tube for excessive movement. The maximum allowable movement is 0.76 mm (0.03 inch).
Check the seal for the top inner tube for wear and damage.
Check the drain hole at the lower edge of the bottom mast casting.
Check the mounting hole for stripped threads or otherwise damaged threads.
Verify that the retaining ring is present and properly seated in the groove at the top of the inner mast tube.
Check the shock mount for the mast for damage, loose hardware, or worn parts.
Clean the housing for the mast and the inner mast tube with any standard general purpose cleaner. This includes the following: glass cleaner, kitchen cleaner, foaming type cleaner and water and a mild detergent.
To prevent damage to the masts Do Not use solvents to clean the masts. This includes alcohol, acetone, de-greasers, paint thinners, or other hydrocarbon base type solvents.
To prevent damage to the masts Do Not apply any type of lubricants to the outside surface of the inner mast tube. The coating on the outside surface of the inner mast tube is self-lubricating.
Mechanical Maintenance
The masts must be cleaned, lubricated, and inspected in two year periods. This should be done more frequently if the AccuGrade system is used continuously or if the system is used in extreme environments.Electrical Maintenance
The masts do not require periodic electrical maintenance. The masts only require software updates as new versions are released.General Maintenance and Care for the Laser Receivers
Inspection and Cleaning
Inspect and clean the laser receivers of the AccuGrade system when the laser receivers are removed from the machine or when the laser receivers are serviced. Use the list that follows in order to inspect the laser receivers and clean the laser receivers.
Check the connectors for corroded contacts or dirty contacts.
Check the connectors for stripped threads or otherwise damaged threads.
Clean the laser receiver lenses with glass cleaner or water and a mild detergent.
To prevent damage to the masts laser receivers Do Not use solvents to clean the laser receivers. This includes alcohol, acetone, de-greasers, paint thinners, or other hydrocarbon base type solvents.