KIT- 4732594 - Caterpillar

Tilt Lever for General Purpose, Multipurpose and Side Dump Buckets
Bucket Dump Position (1.) - PUSH the lever FORWARD for DUMP position. When the lever is released, it will return to HOLD position, and the bucket will remain in DUMP position. Bucket Hold Position (2.) - The bucket will remain in the position it was in when the lever was released. Bucket Tilt Back Position (3.) - PULL lever BACK from HOLD position for TILT BACK position. After dumping, the lever can be placed in the TILT BACK detent to return the bucket to the preset bucket angle. The tilt lever will return to HOLD when the preset bucket angle is reached. The preset angle can be adjusted with the bucket positioner linkage. The tilt back detent only functions after dumping. The tilt back detent is used to return the bucket to the preset bucket angle. When the preset bucket angle is reached, the tilt control lever should return to hold.Lift Lever for General Purpose, Multipurpose and Side Dump Buckets
Float Position (1.) - When the lever is PUSHED all the way FORWARD into detent, the bucket will be in FLOAT. In this position the bucket will lower to the ground and float, following ground variations.Lever will remain in FLOAT position (detent) until manually released by pulling it out of detent position. Lever will then return to HOLD position.
Do not move the lever to FLOAT position with the bucket loaded and raised.
Lower Position (Power Down) (2.) - PUSH the lever FORWARD from HOLD position to lower the bucket. When the lever is released, the lever will return to the HOLD position. Hold Position (3.) - The lift arm will remain in the position it was in when the lever was released. Raise Position (4.) - PULL the lever BACK from HOLD position to RAISE bucket. Release lever to stop lifting bucket. Lever will return to HOLD position. The lever is detended at the full RAISE position, and will stay in detent until bucket reaches a predetermined height set by lift kickout linkage. The lever returns to HOLD when the bucket reaches the predetermined height.Log or Lumber Fork Tilt Lever
1. Fork Tilt Forward Position - PUSH the lever FORWARD from HOLD position to tilt the fork FORWARD. When the lever is released, it will return to HOLD position, and the fork will remain in fork tilt FORWARD position.2. Fork Tilt Hold Position - The fork will remain in the position it was in when the lever was released.3. Fork Tilt Back Position - PULL the lever BACK from HOLD position to tilt the fork BACK. After unloading, the lever can be placed in the TILT BACK detent to return the fork to the