KIT-BARRIER 4802216 - Caterpillar

Use caution to avoid possible personal injury when adjusting the attachment lift kickout.Keep personnel off the machine. Clear the area when working under or around the attachment linkage.With the attachment raised, proper support must be provided for the attachment and/or the linkage.
Start the engine. Raise the work tool to the maximum height and stop the engine.
Block up the work tool and the linkage.
Illustration 1 g01033596
Adjust control group (1) and magnet (2) so that the face of the control group is 6 2 mm (0.24 0.08 inch) away from the magnet. Tighten bolts.
To check the adjustment, remove all blocking.
Start the engine. Move the lift control lever to the RAISE detent position. When the work tool reaches the preset lift height, the lift control lever should return to the HOLD position.
If the kickout position is not correct, perform Steps 1 through 5 again. Note: To adjust to a lower lift kickout height, rotate the plate to the desired angle.