KIT- 4883824 - Caterpillar

Required Parts
Table 1
Part List
Item Qty Part Number Part Name
1 2 - Plate(1)
(1) Dealer fabricatedBowl Measurement
Illustration 1 g06318832
(A) 6.0 mm (0.24 inch)
Measure the gap (A) between the bowl and the apron on each side of the bowl.
Verify that there is a 6.0 mm (0.24 inch) gap between the bowl side and the apron on each side of the bowl to accommodate the new liners. If there is not a 6.0 mm (0.24 inch) gap between the bowl side and the apron, the liner will have to be made from a thinner material.Dealer Fabrication
Illustration 2 g06317578
(1) Plate
(D1) 6 mm (0.2 inch)
(D2) 1432 mm (56.4 inch)
(D3) 1156 mm (45.5 inch)
(D4) 857 mm (33.7 inch)
(D5) 557 mm (21.9 inch)
(D6) 25 mm (1.0 inch) radius
(D7) 257 mm (10.1 inch)
(D8) 50 mm (2.0 inch) radius
(D9) 26 mm (1.0 inch) diameter 10 holes
(D10) 300 mm (11.8 inch) radius
(D11) 10 mm (0.4 inch) radius
(D12) 1285 mm (50.6 inch)
(D13) 1142 mm (45.0 inch)
(D14) 1019 mm (40.1 inch)
(D15) 927 mm (36.5 inch)
(D16) 758 mm (29.8 inch)
(D17) 640 mm (25.2 inch)
(D18) 502 mm (19.76374 inch)
(D19) 281 mm (11.1 inch)
(D20) 241 mm (9.5 inch)
(D21) 126 mm (5.0 inch)
(D22) 655 mm (25.8 inch)
(D23) 360 mm (14.2 inch) radius
(D24) 1137 mm (44.8 inch)
(D25) 1314 mm (51.7 inch)
Fabricate two plates (1) out of 6.0 mm (0.24 inch) Hardox 400 steel as per dimensions shown in Illustration 2.Note: If the bowl measurement does not show enough gap for a 6.0 mm (0.24 inch) liner plate on each side, then plate (1) will have to be made from thinner material.Rework Procedure
Remove the apron lift and apron from the machine.Refer to Disassembly and Assembly, KENR8884, Apron Lift - Remove and Install