KIT-SEAL 5039744 - Caterpillar

124-3079 Front Axle
Illustration 1 g00537540
(1) Diameter of 112-9629 Pin ... 55.00 + 0.00 - 0.05 mm (2.165 + .000 - .002 inch) (2) Use the following washers to attain a maximum gap of 0.8 mm (.032 inch). 9R-9702 Washer ... 1.6 mm (0.06 inch) 1K-7082 Washer ... 0.8 mm (0.03 inch) (3) Thickness of 165-8996 Thrust Washer ... 5.00 0.25 mm (0.197 0.010 inch) (4) Apply 7M-7456 Compound to the outside surface of the 9X-7708 Seal Assembly. Install the 9X-7708 Seal Assembly with the radius toward the inside. (5) Inside diameter of 9R-5246 Sleeve Bearing after installation ... 55.236 0.044 mm (2.1746 0.0017 inch) (6) Apply 5P-3413 Pipe Sealant to the threads of the 8T-4171 Bolt. Tighten the bolt to the following torque. ... 12 3 N m (9 2 lb ft) (7) Tighten 148-8407 Plug to the following torque. ... 35 3 N m (26 2 lb ft) (8) Tighten the 8T-8549 Locknut to the following torque. ... 100 20 N m (74 15 lb ft) (9) Apply grease to the bearings before assembling the bearings on the spindle. (10) Tighten the 8T-3990 Nut to 75 N m (55 lb ft). Turn the nut counterclockwise to the nearest locking hole. Install the 3B-4631 Cotter in the locking hole. (11) Diameter of 160-1014 Pins ... 40.00 + 0.00 - 0.05 mm (1.575 + .000 - .002 inch) (12) Tighten the 6V-7744 Locknut to the following torque. ... 55 10 N m (40 7 lb ft) (13) Inside diameter of 9R-1917 Sleeve Bearing after installation ... 40.153 0.043 mm (1.5808 0.0017 inch)