KIT-SEAL 5144606 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 3S-6224 Electric Hydraulic Pump (115 Volt)(1) 1
6V-3175 Double Acting Cylinder 1
4C-9634 Puller Stud 1
9U-6832 Nut 1
5P-8625 Receiving Sleeve 1
9U-5339 Bearing Puller Adapter 1
B 3S-6224 Electric Hydraulic Pump (115 Volt)(1) 1
6V-3175 Double Acting Cylinder 1
4C-9634 Puller Stud 1
9U-6832 Nut 1
4K-0684 Hard Washer 1
5P-8625 Receiving Sleeve 1
9U-5336 Bearing Puller Adapter 1
(1) 8S-8033 Electric Hydraulic Pump (230 Volt) is available.Start By:
Remove the bucket control linkage. Refer to Disassembly and Assembly, "Bucket Linkage - Remove".
Illustration 1 g00698265
Remove lip seals (1) from the power link (2).
Illustration 2 g01213106
Attach a suitable lifting device to Tooling (A), as shown.
Use Tooling (A) to remove sleeve bearing (3) from the open end of the power link.
Use Tooling (A) to remove the sleeve bearing from the opposite side of the power link.
Remove the sleeve bearings from the closed end of the power link by using Tooling (A).
Illustration 3 g00698407
Remove lip seals (4) from the bore for the idler link in the stick.
Illustration 4 g00698417
Attach a suitable lifting device to Tooling (B), as shown.
Use Tooling (B) to remove the sleeve bearing from the stick.
Use Tooling (B) to remove the sleeve bearing from the opposite side of the stick. Installation Procedure
Install seals (1), (4), and bearings (3) in reverse order of removal.