KIT-ENGINE GASKET 5167293 - Caterpillar

Illustration 6 g00888742
Pressure Test Point for the regulated pump pressure
The regulated pump pressure can be tested at test point (6). Remove the plug from the test point. Use suitable fittings from Table 1 in order to install the 8T-0855 Pressure Gauge (0 to 4,000 kPa (0 to 580 psi)).
Start the engine and operate the engine at 2350 rpm +100 or - 50.
The pressure should be 1625 75 kPa (235 11 psi) when the engine is operating at HIGH IDLE at a temperature of 80 °C (176°F).
Remove the fittings and install the plug that was removed from the test point.Operating Pressures of Clutches and Synchronizers
Introduction
The pressure tests for the clutches and synchronizers are designed to test the operation of the solenoid valves for the transmission. If the pressures at the test points are within the given parameters then it is likely that the solenoid valves for the transmission are operating correctly. If the pressures at the test points are not within the acceptable range refer to Telehandler Machine Systems Troubleshooting, RENR5195.Test Procedure
Pressure gauges are used in the following test procedure.
Move the machine to a smooth, horizontal location that is away from operating machines and away from personnel.
Permit only one operator on the machine. Keep all other personnel away from the machine or in the operator's sight.
Move the transmission control to the NEUTRAL position.
Lower the boom. If equipped, lower the work tool to the ground.
Engage the parking brake and stop the engine.
Place wheel blocks in front of the wheels and behind the wheels.
If the machine is in a confined area, ensure that exhaust gases are vented to the outside when the engine is operated.
Install the 9U-7400 Multitach Tool Group or the ET on the engine in order to enable an accurate measurement of the engine speed (rpm). Refer to Special Instruction, NEHS0605 for further information on the use of this 9U-7400 Multitach Tool Gp .
Illustration 7 g01075877
(1) Pressure test point (forward clutch) (2) Pressure test point (reverse clutch)
Illustration 8 g00888828
(8) Pressure test point (synchronizer for the third speed) (9) Pressure test point (synchronizer for the first speed)
Illustration 9 g01075880
(3) Pressure test point (synchronizer for the fourth speed) (4) Pressure test point (synchronizer for the second speed) (5) Pressure test point (synchronizer for the fifth speed)Note: The test point for the fifth speed is shown for the optional five speed powersynchro transmission.
The operating pressures of clutches and synchronizers can be tested at the test points that are shown in Illustration 7, Illustration 8 and Illustration 9. Remove the plug from the desired test point. Use suitable fittings from Table 1 in order to install the 8T-0855 Pressure Gauge (0 to 4,000 kPa (0 to 580 psi)).
Start the engine and operate the engine at LOW IDLE 950 RPM.
Place the machine into forward gear in order to test the forward clutch pressure. To test the pressure for the reverse clutch, place the transmission in reverse gear.
The correct oil pressures for each test point are shown in Table 2 and table 3.
Table 2
Clutch     Disengaged