KIT-SEAL 5170786 - Caterpillar

5170786 KIT-SEAL Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5170786
517-0786
5170786

Weight: 0.21 pounds 0 kg.

Buy KIT-SEAL 5170786 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 8

Caterpillar 5170786 Parts scheme KIT-SEAL

For full view, you need register

Information:

Installation Procedure
All plugs and caps must be remain in position until the component is about to be installed
Rotate gear on the fuel injection pump in order to align the timing marks. Align the timing marks, refer to Systems Operation Testing and Adjusting, "Fuel Injection Timing - Check" for more information.
Illustration 1 g03850301
Illustration 2 g03818192
Illustration 3 g03818187
Install new O-ring (22) to fuel injection pump assembly (10).
Install fuel injection pump assembly (10) to the front housing. Ensure that the timing mark on the fuel injection pump gear and the camshaft gear are aligned as shown in Illustration 2.
Install bolts (13), (14), (16), (17), (18), (19), and (20). Install nut (15). Tighten nut (15) and bolts (13), (14), (16), (17), (18), and (19) to a torque of 10 N m (88 lb in).
Install new fuel line (7) and tighten nuts (6) and (8) to a torque of 23 N m (204 lb in). Note: If the high-pressure fuel line clamp was repositioned during disassembly, return the clamp to the original position.
Install banjo bolt (9) with new sealing washer (not shown) and tighten the bolt to a torque of 13 N m (115. lb in).
Connect the fuel hose assembly to fuel inlet (21).
Reconnect the harness assembly to fuel temperature sensor (12) and fuel solenoid (11).
Illustration 4 g03819043
If necessary, replace O ring seal (4). Install O ring seal (4) into cover (5).
Install plate (3) and clip (2) complete with harness. Install bolts (1) and tighten to a torque of 26 N m (230 lb in).
Install the fuel filter base, refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install" for the correct procedure.
Turn the fuel supply to the ON position. Turn the battery disconnect switch to the ON position.
Prime the fuel system, refer to Operation and Maintenance Manual, "Fuel system - Prime".
After replacement of the fuel injection pump, the fuel injection pump must be calibrated in order to prevent damage to the fuel system. Use the electronic service tool to perform "Fuel Pump Learn".