KIT 5293515 - Caterpillar

Removal Procedure
Start By:
Remove the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Remove".
Remove the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If the front housing is not installed, do not turn the crankshaft. Damage to the engine may occur.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01357158
Typical example
If the engine is equipped with a turbocharger, disconnect the hose from connection (1) .
Remove nuts (4) and bolts (9) .
Remove cover (8) and O-ring seal (7) .
Remove fasteners (3) . Identify the position of the different fasteners for installation.
Carefully remove front housing (6) from plate (5) . Ensure that pin (2) remains in the front housing.Note: The front housing is aligned to the plate and to the cylinder block with dowels.
Remove the joint (not shown).