AVSPARE.COM
parts catalog

KIT-BEARING 5302193 - Caterpillar


5302193 KIT-BEARING Caterpillar parts
Rating:
41
Alternative (cross code) number:
CA5302193
530-2193
5302193
Caterpillar 5302193 KIT-BEARING
Weight: 0.01 pounds 0 kg.

Buy KIT-BEARING 5302193 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Engage screed lock mechanism (6) on both sides of the machine.
Move screed lift switch (5) to the FLOAT position. Move the screed lift switch on the right instrument panel to the FLOAT position.Note: The screed lift switch on both instrument panels must be in the FLOAT position in order for the screed to lower.
After the screed is resting on the screed lock mechanisms, move screed lift switch (5) to the HOLD position.
Illustration 20 g02131286
Move right screed extend switch (8) to the EXTEND position. Release the switch when the right screed extender is fully extended.
Move left screed extend switch (7) to the EXTEND position. Release the switch when the left screed extender is fully extended.
Illustration 21 g02131287
Move throttle control switch (9) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (10) to the OFF position.
Move engine start switch (10) to the ON position. Do not start the engine.
Illustration 22 g02131288
Press home key (11) .
Illustration 23 g02131290
Press down key (12) until "Service" is highlighted on the display screen.
Press OK key (13) .
Illustration 24 g02131291
Press down key (12) until "Calibrations" is highlighted on the display screen.
Press OK key (13) .
Illustration 25 g02131373
Press down key (12) until "Right Paddle Sensor" is highlighted on the display screen.
Press OK key (13) .
Illustration 26 g02131374
Press OK key (13) in order to begin the calibration.
Illustration 27 g02131375
Press OK key (13) .
Illustration 28 g02131376
Illustration 29 g02131377
Hold right paddle (14) in the full OFF position at approximately 45 degrees. Press OK key (13) .
Illustration 30 g02131378
Illustration 31 g02131380
Place right paddle (15) in the full ON position (straight down). Press OK key (13) .
Illustration 32 g02131382
The display should now read "CALIBRATION COMPLETE". Push back key (16) to return to calibration screen.
Push home key (11) in order to exit the calibration screen.
Move engine start switch (10) to the OFF position.


Parts kit Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.