KIT-HAMMER 5329087 - Caterpillar

Restoring Display Settings or Machine Settings
Use the "Restore Settings" dialog in order to restore previously saved display settings or machine settings. From this dialog, you can restore the full Display configuration settings. The settings may be stored in the previously saved files:
"Display Settings File"
"Machine Settings Files"Ensure that you restore the correct machine settings file for your machine. Display settings files can be used for any machine.Note: The machine settings file contains the machine dimensions. Use the machine settings file on the same machine that the file was created on.Note: When you restore the Display or the machine settings, the GPS receiver configuration settings and the Display brightness settings are not changed.The AccuGrade System will restore the angle sensor calibration settings.Note: Sensor calibration settings for the sensors are saved in a machine settings file, and are restored when you restore the settings file.The "Restore Settings" dialog lists the settings files on the data card.In order to access the "Restore Settings" dialog, complete the following steps:
Ensure that there is a data card inserted into the Display.
From the "Setup Menu – Configuration" dialog, press the Down arrow or the Up arrow until "Restore Settings" is highlighted.
Press the "OK" key.The "Restore Settings" dialog appears that lists the setting files that are on the data card. Refer to Illustration 1.
Illustration 1 g01267655
Press the Down arrow or the Up arrow in order to select the settings file that you want.
Press the "OK" key in order to confirm the settings.In order to close the dialog without selecting a settings file, press the "ESC" key. The "Restore Settings" dialog appears.If you attempt to restore an invalid settings file, a warning message appears.
Press the "OK" key.
One of the messages shown in Table 1 will appear depending on what was selected in the "Restore Settings" dialog,
Table 1
Possible Messages    
File Type     Message    
Display settings     "Restoring Display Settings Please wait..."    
Machine settings     "Restoring Machine Settings. Please wait..."    
Press the "ESC" key in order to go back to the "Setup Menu – Configuration" dialog. Press the "ESC" key again in order to exit the "Setup Menu – Configuration" dialog. The changes take effect immediately.Always check the Bucket Dimensions, as the machine bucket tips may have worn (or been replaced) since the Machine Settings were saved.