KIT-FILM 5364720 - Caterpillar

This widget shows parameters that have a list of values instead of a numeric value.Lights
Illustration 14 g06064509
(26) OK, or Unknown
(27) Not OKWhen the lights are green, the status is "OK". When the status is "Not OK", the lights are red.Note: An "Unknown" status will show up as green.Channel Use must include Event or the red light will not display correctly. For example, an alarm sent by the ECM for low oil pressure will display in the alarm list but will not turn the light red.
Illustration 15 g06082736The channel must be configured for an event or the widget will not display on the screen.
Illustration 16 g06082740Indicator symbols
Illustration 17 g06064790
(28) Warning
(29) Alarm
(30) Derate
(31) ShutdownIf a gauge shows a parameter in an alarm state, a symbol will appear on the gauge to indicate what type of alarm is present. The symbol will remain on the gauge until the alarm is gone. Refer to Alarm List for further information.Soft Keys (3)
Illustration 18 g06064845
(32) Back
(33) Forward
(34) Return to previous screen
(35) Language Selection
(36) Backlight Control (replaced by Gear Control when enabled)
(37) Start Immediately, Activate Shutdown Override Mode
(38) Activate selection for editing
(39) Gear Control (replaces Backlight when enabled)
(40) Mode Selection
(41) OK (accept changes)
(42) Activate the selection
(43) Start the engine
(44) Cycle through the starter options. This function is only available when two starters are configured.
(45) Stop the engine
(46) Activate the next tab on the top
(47) Cycle through the options
(48) Unit SelectionThe function of the soft keys (3) at the bottom of the screen depend on the current screen selection. Refer to Illustration 18.Gear Control
Illustration 19 g06064918If "Gear Control" is enabled on the DCU, the "Backlight" soft key on the main display will be replaced with a "Gear" soft key. The "Gear" soft key navigates to the "Gear Control" screen seen in Illustration 19.Engine Speed
The "Engine Speed" gauge is the same widget found on the other screens.Shaft Speed
The "Shaft Speed" gauge refers to the propeller shaft speed. This gauge may be configured to show forward and reverse on different sides as seen in Illustration 19. The gauge may also be configured as a regular gauge like "Engine Speed".Gear
Illustration 20 g06064928
(49) Forward
(50) Reverse
(51) In Gear
(52) Neutral
(53) UnknownDepending on the DCU configuration, the "Gear" indicator may show "Forward" and "Reverse", or the indicator may only show "In Gear".When a gear change is requested, the arrow will show the current gear. The letter will flash and show the requested gear. Refer to the gear indicators in Illustration 20.RPM Interlock
Illustration 21 g06064936
RPM Interlock
(54) Active
(55) InactiveThe "RPM Interlock" indicates that the engine is turning too fast to engage the transmission. This interlock will prevent gear selection.Shaft Lock
Illustration 22 g06064940
Shaft Lock indicator
(56) Active
(57) InactiveThe "Shaft Lock" icon indicates whether the shaft lock is engaged or disengaged.Soft Keys
If the "RPM Interlock" and "Shaft Lock" are not engaged, the soft keys can be used to request a gear change. The following soft keys are available:
Ahead
Neutral
Astern