KIT-MAJOR 5385415 - Caterpillar

Illustration 4 g01414954
Remove plug (6) from plate (5).
Remove spiral lock ring (4).
Illustration 5 g01414955
Install Tooling (B) in plate (5). Tighten Tooling (B) to remove plate (5) from the track roller frame.
Illustration 6 g00525912
Position Tooling (C) under the front track roller frame, as shown. Support the weight of the roller frame with Tooling (C).
Illustration 7 g01414960
Remove bolts (8) that hold retainer assembly (7) to the main frame case.
To prevent damage to the pivot shaft seal, make sure the bolts that hold the pivot shaft seal retainer to the main frame case has been removed before the equalizer bar is disconnected.
Illustration 8 g01414529
Remove bolts (9) and the nuts that clamp pin (10) in place in the track roller frame.
Remove the retaining ring and the spacer from the end of pin (10).
Illustration 9 g00525919
Attach Tooling (D), as shown. Fasten a suitable lifting device to Tooling (D).
Use Tooling (D) to remove pin (10) from the track roller frame.
Illustration 10 g00525920
Personal injury or death can result from lifting a heavy assembly.The heavy assembly can fall if using an incorrect hoist to lift the load.Be sure the hoist has the correct capacity to lift a heavy assembly. Approximate weight of the assembly is given below.
Pinch PointStay clear of this area!Serious personal injury may occur.
Fasten a suitable lifting device and Tooling (E) to the track roller frame. Support the weight of the track roller frame with the suitable lifting device. The weight of the roller frame is approximately 9979 kg (22000 lb).
Remove Tooling (C) from the front frame.
Illustration 11 g01414538
Remove bolts (11) and plate (12) that holds the track roller frame to the pivot shaft.Remove the thrust ring.
Use a suitable lifting device and Tooling (E) to remove the track roller frame.
Illustration 12 g01414549
(13) Thrust plate
Remove O-ring seal (15).
Fasten a suitable lifting device to retainer assembly (7). The weight of retainer assembly (7) is approximately 34 kg (75 lb). -Remove bolts (14) that hold retainer assembly (7) to the track roller frame and remove retainer assembly (7).
Illustration 13 g01414735
Remove O-ring seal (17) from retainer (16).
Use a hammer and a chisel to remove seal assembly (18) from retainers (16) and (19).
Remove plate (13) from retainer (7). Refer to Illustration 12 for the location of plate (13).
Illustration 14 g01414747
If necessary, remove bearings (20) from the track roller frame.