KIT-ENGINE GASKET 5410038 - Caterpillar

Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Personal injury can result from contact with hot hydraulic oil and from contact with hydraulic oil that is under high pressure.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. The hydraulic oil pressure must be released before any service on the hydraulic system is performed or serious personal injury could occur.Verify that all of the work tools have been completely lowered to the ground. Release the hydraulic oil pressure at the hydraulic tank through the breaker relief valve when the breaker relief valve is cool enough to touch with your bare hand. Verify that the hydraulic oil is cool before you begin to remove any hydraulic components or hydraulic lines.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids.Dispose of all fluids according to local regulations and mandates.
Note: Use the information in the reference to prepare the machine for this test. Also, use the information in the reference to relieve any system pressure that may be present in the hydraulic system.ReferenceFor the correct procedure to prepare the machine for this test, refer to Testing and Adjusting, "Machine Preparation for Troubleshooting" for the machine that is being serviced.ReferenceFor the correct procedure to relieve any hydraulic oil pressure that may be present in the hydraulic system, refer to Testing and Adjusting, "System Pressure - Release" for the machine that is being serviced.
Table 1
Required Tools    
Description    Qty    
Container for Measuring     1    
Hose for Draining Oil     1    
Place the machine on level ground.
Illustration 1 g01162081
The switch for the hood
Open the hood for the engine compartment.
Shut off the engine.
Release all the pressure in the hydraulic system. For information on the correct procedure to release all the hydraulic oil pressure, refer to the reference at the beginning of the test.
Illustration 2 g01053295
Swing motor, swing drive and pilot manifold (1) Case drain line
Disconnect the case drain line (1) from the elbow. Plug case drain line (1) .
Attach a hose to the elbow. Place the open end of the hose into a suitable container for measuring the fluid.
Illustration 3 g01070478
Remove the cover underneath the machine in order to access the pilot manifold.
Illustration 4 g01398174
The solenoid for the swing parking brake is located on the pilot manifold. Current model
Disconnect the wire from the solenoid for the swing parking brake.
Start the engine.
Place the engine speed dial to high idle.
Increase the hydraulic oil temperature to 55 5°C (130 10°F).
Illustration 5 g01162712
Hydraulic lockout control
Move the