KIT (Master Cylinder) 5G4030 - Caterpillar

4W9186 Governor Control Group Changes
To update the 4W9186 Governor Control Group based on 3304B and 3306B Engines, make the following changes.
1. Adjust the handle so that it is vertical at low idle. The handle must be in the right hand notch of the quadrant and within 5° of vertical. See Illustration 1.2. Make sure that the rod ends of the linkage are attached to the correct holes in the levers. See Illustration 2.3. With the handle in the right hand notch of the quadrant, adjust the linkage so that point (A) is 3.0 1.5 mm (.12 .06") above the line from point (B) to point (C) when the engine is at rated load and rpm. See Illustration 2.
Illustration 1. Handle location at low idle.
Illustration 2. Linkage adjustment for 4W9186 Governor Control Group.2W3469 Governor Control Group Changes
To update the 2W3469 Governor Control Group used on 3406B Engines, make the following changes.
1. Replace the former 6S4454 Rod with a new 1L2313 Rod. See Illustration 3.2. Adjust the angles and rod length as shown in Illustration 3.Angles and rod length for 60 HZ rating:
... Angle (D)...44°... Angle (E)...14° 2°... Angle (F)...60°... Angle (G)...5°... Length (H)...182 2 mm (7.2 .1") Angles and rod length for 50 HZ ratings:
... Angle (D)...24°... Angle (E)...14° 2°... Angle (F)...52°... Angle (G)...20°... Length (H)...173 2 mm (6.8 .1")
Illustration 3. Adjustments for 2W3469 Governor Control Group.8N2365 Governor Control Group Changes
To update the 8N2365 Governor Control Group used on 3408B and 3412 Engines, make the following changes.
1. Install the new parts listed in the chart.2. Adjust the rod length and angle as shown in Illustration 4.
Illustration 4. Changes to 8N2365 Governor Control Group.