KIT-GASKET 6V0714 - Caterpillar

Industrial Engines:
C-15 (S/N: BEM1-UP)
C-16 (S/N: BFM1-UP)
3406E (S/N: 6BR1-UP)
3456 (S/N: 3LW1-UP)
Marine Engines:
3406E (S/N: 9WR1-UP)
Generator Set Engines:
3406E (S/N: 9NN1-UP; 8AZ1-UP)
Testing and Adjusting, RENR2347-00, "C-15 and C-16 Industrial Engines", "Electronic Unit Injector - Adjust"Testing and Adjusting, SENR1067-01, "3406E and 3456 Industrial Engines", "Unit Injector Adjustment"Testing and Adjusting, SENR1168-00, "3406E Marine Engine", "Unit Injector Adjustment"Testing and Adjusting, SENR2303-00, "3406E Generator Set Engines", "Electronic Unit Injector - Adjust"The torque of the adjusting screw locknut for the unit injector has been changed. The torque was 81 10 N m (60 7 lb ft). The new value for the torque of the adjusting screw locknut has been increased to 100 10 N m (74 7 lb ft). The new torque should be used only if the unit injectors require adjustment. The change is shown in the text that follows.
Table 1
Tools Needed    
Part Number     Part Name     Quantity    
9U-7227     Injector Height Gauge     1    
Illustration 1 g00294868
Injector Mechanism (1) Rocker arm (2) Adjusting screw (3) Locknut (4) 9U-7227 Injector Height Gauge To make an adjustment to the unit injectors on cylinders 3, 5, and 6 use the following procedure:
Put the No. 1 piston at the top center position on the compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Injector height gauge (4) is used in order to obtain a dimension of 78.0 0.2 mm (3.07 0.01 inch). The dimension is measured from the top of the unit injector to the machined ledge of the fuel injector body.
Turn unit injector adjusting screw (2) clockwise until the correct height is obtained.
Hold the adjusting screw in this position and tighten locknut (3) to a torque of 100 10 N m (74 7 lb ft).
To make an adjustment to the unit injectors on cylinders 1, 2, and 4, remove the timing bolt. Turn the flywheel by 360 degrees in the direction of engine rotation. The direction of engine rotation is counterclockwise, as the engine is viewed from the flywheel end. This will put the number 1 piston at the top center position on the exhaust stroke.
Repeat Steps 3 through 4.
Remove the timing bolt from the flywheel after all the unit injector adjustments have been made. Reinstall the timing cover.